If Your Ecosmart ™ Beeps For Help - Fisher & Paykel WA42T26GW1 Guide D'installation Et D'utilisation

If your Ecosmart
US
30
CA
Before you call for service
Please read the following pages before calling for service.
You can correct many of your machine's problems using the checklists on the following pages.
Your machine is capable of diagnosing its own problems. If it has a problem it will beep and
display a message telling you what is wrong.
Musical series of beeps
* The beeps are the same sound your washer makes when you plug your machine in.
HOT water temperature light is flashing.
Hot faucet has not been turned on.
Inlet hose filters may be blocked.
Hot water supply is not hot enough to maintain the wash temperature you have selected.
Select a lower wash temperature.
Inlet hoses connected the wrong way around.
COLD water temperature light is flashing.
Cold faucet has not been turned on.
Inlet hose filters may be blocked.
Inlet hoses connected the wrong way around.
Cold water temperature exceeds recommended limits.
HOT and COLD water temperature lights are flashing.
The faucets have not been turned on.
Inlet hose filters may be blocked.
The drain hose is too low and the water is siphoning out of the machine.
The flow rate of the supply water is too slow.
HIGH water level light is flashing.
The machine is overloaded and can not agitate. Ensure the machine is stationary. Remove
items until the remaining ones can move more freely.
Select a higher water level.
First RINSE light or SPIN light is flashing.
The machine has a suds build-up. Too much detergent may have been used for the amount of
soil in the load. Wait for suds to dissolve. Rinse clothes using a deep rinse.
beeps for help
™
every 5 seconds and...
*