Operating Problems - Fisher & Paykel WA42T26GW1 Guide D'installation Et D'utilisation

Operating problems

US
32
CA
Pressing POWER does not turn the machine on.
Is the power switched on?
Unplug machine from the wall. Wait 60 seconds, plug back in and operate the machine.
Could your household power supply be at fault? Try plugging in another electrical appliance.
Pressing START/PAUSE does not start the fill.
Are both hot and cold faucets turned on?
Are the inlet hose filters blocked?
Is DELAY START on?
Is the lid up?
FILLING continuously.
Check that the machine is not siphoning.
Check the black hose guide is installed.
NOT SPINNING properly.
Is the load out of balance? (Refer to pages 21 and 26).
Check the machine is level and does not rock.
It may have suds build-up (refer spin light flashing, page 30).
SPIN SPEED sounds slower than it should.
The clothes are unevenly distributed in the wash tub, your Ecosmart™ has compensated by
lowering the spin speed.
Machine is continually going OUT OF BALANCE.
Check the feet are unscrewed and the rubber inserts are fitted so the machine is level and
does not rock.
Too much water for load (refer to page 18).
Too much or too little water when filling on AUTO WATER LEVEL.
It may still be in the process of sensing the water level (refer to page 18).
Some loads do not suit Auto water level (eg pillows, bedding, large bulky items). Manually
select the water level.
Refer to pages 24 to 26 to adjust the Auto fill level.
NOISES.
Banging – the load is out of balance (refer pages 21 and 26).
Other noises – refer page 29.