Fisher & Paykel WA42T26GW1 Guide D'installation Et D'utilisation page 8

Installation instructions
US
6
CA
Inlet hoses
Install hoses with the straight end (with filters)
1
fitted to the faucets (Fig.6).
Install elbow ends onto washing machine (Fig.6).
2
Inlet valves are marked on the back of the machine
H=Hot
Ensure the hot is connected to the hot, and the
3
cold is connected to the cold.
Note: if there is a cold water supply only, an inlet valve cap (available from Fisher & Paykel) MUST
be connected to the hot valve. The cap prevents water leaking from the hot valve. However, we
recommend this product is connected to both hot and cold water.
Leveling the washer
Unscrew the feet so the machine is NOT sitting on
1
the corner cabinets, then fit the rubber leveling
inserts (Fig.7).
Move the washer into its final position. We suggest
2
a minimum clearance of 1" (25 mm) on each side
for ease of installation (Fig.8).
It is IMPORTANT to level the washer to ensure
3
proper performance during spin.
Adjust the feet by unscrewing/screwing to make
sure the washer is level and cannot rock.
Use the walls and adjacent counter tops as a sight
4
guide to check to see if washer appears level.
Readjust the feet if necessary.
Open the lid and check the washer basket to see
5
that it sits slightly forward of centre (Fig.9).
C=Cold
Faucet end Washer end
of hose
Fig.6 Inlet hose ends
Corner cabinets
Adjustable feet
Rubber insert
Fig.7 Adjusting leveling feet
1" (25 mm) 1" (25 mm)
Fig.8 Minimum clearance
Incorrect
adjustment
Fig.9 To check leveling look
down on the wash basket
of hose
Correct
adjustment