Fisher & Paykel WA42T26GW1 Guide D'installation Et D'utilisation page 9

Close the lid. Visually check that the lid and topdeck are aligned. If not aligned, adjust the feet
6
again until the lid and topdeck match (Fig.10).
Turn on water and check hose connections for leaks. Check that there are no kinks in the hoses.
7
Important!
Check all connections for leaks after turning faucets on, and again after 24 hours.
Uncoil the power cord, remove and discard the plastic pin cover and plug into wall socket.
8
Wind left foot down
(out) to correct
Wind right foot down
(out) to correct
Operation
Check for leaks, noise, vibration, correct water temperatures and proper operation in spin. Check
1
that the lid locks during spin.
Turn hot and cold water faucets off when washer is not in use.
2
Special instructions
The washer may give warning signals when low water pressure, or drain problems are
encountered. See "If your Ecosmart™ beeps for help" (page 30).
If further help is needed concerning this appliance, refer to 'Service' , page 37.
Installation instructions
Lid alignment
Lid
Topdeck
Lid
Topdeck
Lid
Topdeck
Fig.10 To assess leveling check lid alignment
US
7
CA