Light Sensitivity (Iso); Manual Partial Light Output (P) - Metz MECABLITZ 58 AF-2 digital Mode D'emploi

6.5 Light sensitivity (ISO)

If there is no digital data transfer between the camera and flash unit, the ISO can
be manually set from 6 to 6400.
A
For flash modes (automatic) and
have to be set to the same ISO value.
Setting procedure:
• Press the
A F 8.0
hes on the LC display.
MZoom 35
12 m ISO 200
Para – +
F 8.0 • Set the desired ISO value using the
A
tons. The setting takes effect immediately.
MZoom 35
17 m ISO 400
+
Para –
• Press the button to change the LC display back to the normal view. If the
button is not pressed, the display will change back to the normal view
after about 5 seconds.
During E-TTL flash mode, setting the ISO on the flash unit is only necessary to
achieve the correct distance range indication, not for the function of the flash.
M
(manual), the camera and flash unit
button (Parameters) until „ISO" flas-
Para
+
–
/

6.6 Manual partial light output (P)

M
In the manual mode
adjusted to fit the shooting situation with the manual partial light output parame-
ter (P). Settings in manual flash mode M range from P 1/1 (full light output) to P
1/256, in intervals of 1/3.
Setting procedure:
• Press the button (Parameters) until „P" appears
Para
on the LC display.
• Set the desired light output (1/1-1/256) with the
but-
–
/ buttons. The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button
display will change back to the normal view after
about 5 seconds.
☞ In strobe mode
adjusted to fit the flash parameters chosen.
☞ In strobe mode
possible in full intervals.
☞ When the number of flashes (N) and the flash frequency (f) are reset, the
partial light output is not reset.
and the strobe mode , the light output can also be
M
+
M
is not pressed, the
, the maximum partial light output is automatically
, reduction of the manual partial light output is only
F 8.0
MZoom 35
6,1 m P1/8
Para – +
F 8.0
MZoom 35
17 m P1/1
Para – +
125