Flash Exposure Correction (Ev); Light Sensitivity (Iso) - Metz MECABLITZ 58 AF-2 digital Mode D'emploi

6.4 Flash exposure correction (EV)

Manual flash exposure correction (EV) can help offset extreme differences in
contrast between the subject and background. Corrections from -3 f-stops (EV)
to +3 f-stops (EV) can be made, in 1/3 increments (also see 10.5).
Setting procedure:
F 8.0
A
MZoom 35
12 m EV 0
• Press the
+
Para – hes on the LC display.
F 8.0 • Set the desired EV value using the
A
tons. The setting takes effect immediately.
MZoom 35
6,1 m EV+2
Para – +
• Press the button
the normal view. If the button
display will change back to the normal view after
about 5 seconds.
126
Para button (Parameters) until „EV" flas-
+
and
to change the LC display back to
is not pressed, the

6.5 Light sensitivity (ISO)

If there is no digital data transfer between the camera and flash unit, for exam-
ple with cameras from Group A (see table 1) or when using non-CPU–capable
lenses, the ISO can be manually set from 6 to 6400.
A
For flash modes (automatic) and
have to be set to the same ISO value.
Setting procedure:
• Press the Para button (Parameters) until „ISO" flas-
hes on the LC display.
• Set the desired ISO value using the
buttons.
–
but-
The setting takes effect immediately.
• Press the button to change the LC display back to
the normal view. If the button
display will change back to the normal view after
about 5 seconds.
During TTL flash mode, setting the ISO on the flash unit is only necessary to
achieve the correct distance range indication, not for the function of the flash.
M
(manual), the camera and flash unit
F 8.0
A
MZoom 35
12 m
Para
+
–
and
A F 8.0
MZoom 35
17 m
Para
is not pressed, the
ISO 200
– +
ISO 400
– +