Main Reflector Position (Zoom); Flash Exposure Correction (Ev) - Metz MECABLITZ 58 AF-2 digital Mode D'emploi

6.3 Main reflector position (Zoom)

If there is no digital data transfer between the camera and flash unit, the reflector
positions
24 mm - 28 mm - 35 mm - 50 mm - 70 mm - 85 mm - 105 mm (35mm format
24 x 36) can be set manually.
MZoom will then appear in the LC display.
Setting procedure:
• Press the
F 8.0
A
appears on the LC display.
MZoom 35
6.1 m ISO 200
+
Para –
A F 8.0
• Set the desired value using the
MZoom 70
The setting takes effect immediately.
8.1 m ISO 200
+
Para –
• Press the button
the normal view. If the button
display will change back to the normal view after
about 5 seconds.
During digital data transfer between the camera and flash unit, the main reflec-
tor positions are adjusted automatically.
AZoom will then appear in the LC display.
124
button (Parameters) until „Zoom"
Para
+ –
/ buttons.
to change the LC display back to
is not pressed, the

6.4 Flash exposure correction (EV)

Manual flash exposure correction (EV) can help offset extreme differences in
contrast between the subject and background. Corrections from -3 f-stops (EV) to
+3 f-stops (EV) can be made, in 1/3 increments (also see 10.5).
Setting procedure:
• Press the button (Parameters) until „EV" flashes
Para
on the LC display.
• Set the desired EV value using the
tons. The setting takes effect immediately.
• Press the button to change the LC display back to the normal view. If the
button is not pressed, the display will change back to the normal view
after about 5 seconds.
A F 8.0
MZoom 35
12 m EV 0
Para –
+
–
/ but- F 8.0
A
MZoom 35
6,1 m EV+2
Para –
+
+