Door Trip Adjusting - CDV Group DIGIWAY DWS102 Serie Manuel D'installation Et Utilisation

Cancelling
The procedure is identical to the memorisation.
1 - Keep the button P1 pressed down for 4 sec. until the led LP starts to flash GREEN;
2 - Release P1 and push the key of the transmitter which has to be cancelled and verify LP which has to do a
longer pulse and after blinks again, waiting for more transmitters.
3 - Push the keys of all the transmitters to cancel
4 - At the end, if within 6 sec. no more transmitters are activated the LP comes back to stable GREEN and the
procedure finishes.
Full memory erasure
Throught this procedure it's possible to remove all the remote controls memorised.
1 - Keep the button P1 pressed down for 4 sec. until the led LP start to flash GREEN;
2 - Release P1 and push it again until LP does 3 long GREEN flashes.
At that point the memory is completely erased.
NOTE : The first cycle, executed by the door, next to a memory access ( memorization, cancelling, full memory
erasure ) will occur at slow speed.
Additional wireless functions
The remote control provided with the product (2 or 4 keys) allows you to directly modify the NIGHT/DAY mode
setting of the door operator.
The NIGHT mode which usually is set by connecting a close contact across the terminals 12-13 of the
electronic card can be modified by the radio transmitter just by using the B key of the remote control (top right-
hand key of the remote control ).
First of all it's necessary to memorise the B key of the remote control into the memory of the appliance, by
following the procedure on page 30 of the manual. Once memorised, the B key does not act like the remaining
keys (A, C & D) but allows you only to set/unset the NIGHT / DAY mode. To set this mode press and keep
pressed the B key of the transmitter for 5 secs until the external led of the motor becomes ORANGE.
At this point the NIGHT mode has been selected and the EXTERNAL (NIGHT) radar has been disabled. To
return to the DAY mode, press again the B key of the remote for 5 secs until the led returns GREEN.
NOTE : If you connect also the external selector on terminals 12-13, the remote control can select the
NIGHT/DAY mode only if the wired selector is in DAY mode (open circuit). If the external selector is in NIGHT
mode, the function of the key B of the remote control is disabled as the wired setting has the priority.
If you want to re-calibrate the door trip paremeters, follow the procedure below:
1 - Close the door;
2 - Keep the button P1 pressed down for 4 sec. until the led LP starts to flash GREEN;
3 - Release P1 and push it again for 1 sec. : LP starts to flash RED;
4 - Open manually the door for a while: after the first motion the door begins the calibration cycle, opening
at low speed until it is completely open. Then, after the pause time set with the corresponding trimmer, it
closes, always at low speed.
At the end of this calibration cycle LP becomes back GREEN and the procedure finishes.

Door trip adjusting

A CDV Group product
Pag.31