CDV Group DIGIWAY DWS102 Serie Manuel D'installation Et Utilisation page 23

Systeme d'automatisme pour porte simple d'interieur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

First of all, check the stability of the door which has to be motorized, verifying that the motion on both directions
( open and close ) is regular without any friction. If it isn't like that, make all the needed improvements to the
structure.
Foresee a door-stop for the complete open condition.
Parameter
Value (mm)
A
0 - 270
B
28
C
100
D
520
E
65,5
This type of installation is addressed to inswing doors.
1)
Remove the cover and locate the 6 holes position laying the motor to the mounting plate;
2)
Lean the mounting plate to the wall and mark the holes centers referring to the distances shown in the
above figure;
3)
Make 6 holes with diameter Ø 8 mm and insert the 6 special plugs provided ;
4)
Fix the plate to the wall using the special screws provided;
5)
Fix the motor to the mounting plate with the screws M6x14 provided
6)
Plug-in the sliding arm on the motor shaft and screw the fixing screw M6;
7)
Slide-in the sliding block into the guide;
8)
Lean the guide to the door and mark the 4 fixing holes;
9)
Remove the sliding block and fix the guide to the door by using the 4 special screws provided;
10) Slide-in completely the white strip on the guide;
11) Slide-in back the sliding block into the guide and insert the two lateral plugs;
12) Make all the electrical wirings;
13) Insert the battery fuse and give power supply;
14) Complete with the cover.
Installation
Sliding arm version
A
C
Description
Door hinge – motor axis distance
Motor cover – guide distance
Guide holes interaxis
Guide lenght
Motor axis - vertical plane distance
C
C
C
D
A CDV Group product
Pag. 23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Digiway dws102a serieDigiway dws102s serie

Table des Matières