CDV Group DIGIWAY DWS102 Serie Manuel D'installation Et Utilisation page 27

LED LP reference messages
Function
ON
Normal mode O
Battery operation
Door open / FTC NC
open
Night mode
Battery low
Severe fealure
Door free
TX Program (*)
Self-calibrating (*)
Door blocked
Electronic card LED reference messages
Led ON
L1 NC Stop photocell closed
L2 NC Re-open photocell closed
L3 Normal mode
L4 Door open (*)
L5 External Radar active (*)
L6 Internal Radar active
L7 Night mode
L8 START input active
Dip-switch settings
Description
Open delay ( only in double
Dip1
door configuration)
Dip2
Push&Go
Dip3
Electrolock & Opening jolt
Dip4 Wind-stop
Dip5 Disabled persons configuration
Dip6 Radar exclusion in closing
The following table shows the settings of Dip2 and Dip4 for the functions Push&Go and Wind-Stop.
The function Wind-Stop can be set to max level, medium level or disabled depending upon the position of dip2 and dip4.
Push&Go Wind-Stop
( Dip2 ) ( Dip4 )
OFF OFF
OFF ON
ON ON
ON OFF
GREEN LED ORANGE LED
Blink ON Blink
O
O
O
- - - -
O
NC Stop photocell open
NC Re-open photocell open
Door free
Door free
Day mode
Main door N° 1 open first and close last. Synchronization
effected with a signal coming out from the main motor
When enabled allow the opening simply by pushing the door. Active only to open.
See next table for settings
Electrolock enabled with a 240 mS of closing pulse
before the opening
The door is kept closed all the time even when different pressure could open the
door. – See next table for settings.
Special Settings for disabile persons requirements ( see
next paragraph )
External radar excluded
Function
Both functions disabled
Function Wind-stop max
Function Wind-stop medium
Function Wind-stop disabled
RED /
RED LED
GREEN
ON Blink Blink
O
O
- - -
O
O
Led OFF
-
-
-
ON
A CDV Group product
(*) : Different blinking frequency
(*) : In day mode only
OFF
Function disabled
Function disabled
Function disabled
Internal radar excluded
Pag. 27