CDV Group DIGIWAY DWS102 Serie Manuel D'installation Et Utilisation page 24

This part is addressed to outward door installations
1) Remove the cover and locate the 6 holes position laying the motor to the mounting plate;
2) Lean the mounting plate to the wall and mark the holes centers referring to the distances shown in the
figure below;
3) Make 6 holes with diameter Ø 8 mm and insert the 6 special plugs provided ;
4) Fix the plate to the wall using the special screws provided;
5) Fix the motor to the mounting plate with the screws M6x14 provided
6) Fix the bracket to the door referring to the distance A of the table below;
7) Plug in the articulated arm on the motor shaft and screw the fixing screw M6;
8) If the distance between the motor and the door is higher than that allowed, use the extension
provided;
9) Fix the arm to the motor by using the screw M6x75 provided;
10) Make all the electrical wirings;
11) Insert the battery fuse and give power supply;
12) Complete with the cover.
L3
Pag. 24
Articulated arm version
L1
L2
A
B
Parameter Value ( mm )
A
B
A-B Min 80
C
L1
L2
130 - 300
L3
A CDV Group product
C
Description
350 Door hinge - door bracket distance
270 Door hinge - motor axis distance
Motor axis - door bracket distance
40 Bracket holes distance
65,7 Motor axis - wall distance
300 Base lever
Arm extension