Metrohm 774 Oven Sample Processor Mode D'emploi page 133

5.11.6.7
5.11.6.8
5.11.6.9
5.11.6.10
5.11.6.11
774 Oven Sample Processor, Mode d'emploi
5.11 Description of the remote control commands
Assembly.Scan
Assembly.Scan.Address
Assembly.Scan.Pattern
with Rm (parallel/Remote):
with RS (serial/RS232):
Scanning the interfaces.
.Address Selection of interface (Remote / RS232)
.Pattern Signal or character string
This function is not applicable for process control via RS232 interface. See
&Info.ActualInfo.Inputs and ...Outputs (5.11.3.14 and 5.11.3.15) instead.
Assembly.Ctrl
Assembly.Ctrl.Address
Assembly.Ctrl.Pattern
with Rm (parallel/Remote):
with RS (serial/RS232):
Signal or data transmission via interfaces.
.Address Interface selection (Remote/RS232)
.Pattern Signal or character string
With the Remote interface predefined bit patterns may be applied using the
short names listed above (see page 98ff).
Assembly.Def
Assembly.Def.Object
Assembly.Def.Address
Assembly.Def.Value
Definition of various device settings. Depending on the selected item in
...DEF.Object different parameters and ranges may be entered.
Def.Object Def.Address
DOSRATE
FILLRATE
LIFTRATE
SHIFTRATE auto., +, –
DRIVE.PORT [1...12].[1...4]
&Assembly.Def;$G triggers this function.
Assembly.Wait
Assembly.Wait.Time
Waiting time.
&Assembly.Wait;$G triggers this function.
Assembly.End
$G triggers a RESET (same as the <RACK> key).
START device1, START dos1,
STOP device1, ENTER, INIT
1...12 0.01...160 ml/min
1...12 0.01...160 ml/min
1...2
3...20 ang. degrees/s
dos., fill, rinse, prep., drain
$G, $S
Rm, RS
8 x 1, 0 or ∗ (bin)
ready1, end1, Cond ok.
Cond 737, no error
14 ASCII characters
$G
Rm, RS
14 x 1, 0 or ∗ (bin),
14 ASCII characters
$G
DOSRATE
FILLRATE, LIFTRATE
SHIFTRATE, DRIVE.PORT
depending on .object
depending on .object
Def.Value
3...25 mm/s
$G, $S, $H, $C
0...1...9999 s
$G
127