Control Panel And Features - Maytag W11204389A Guide D'utilisation Et D'entretien

CONTROL PANEL AND FEATURES

Not all features and cycles are available on all models.
NOTE: The control panel features a sensitive surface that
responds to a light touch of your finger. To ensure your
selections are registered, touch the control panel with your
fingertip, not your fingernail. When selecting a setting or
option, simply touch its name.
POWER/CANCEL
1
Touch to turn the dryer on and off. Touch to stop/cancel
a cycle at any time.
CYCLE CONTROL KNOB
2
Turn the knob to select a cycle for your laundry load. Sensor
Cycles are Custom Cycle, Bulky Items, Towels, Sanitize,
Whites, Heavy Duty, Regular, Delicates, Wrinkle Control,
Normal, and Jeans. Timed Cycles are Timed Dry and Quick
Dry. The Steam Cycle (on some models) is Steam Refresh.
See "Cycle Guide" for detailed descriptions of cycles.
The Cycle Control Knob can also be pressed to activate the
Extra Power option for harder-to-dry loads. See the "Options"
section for more information.
START/PAUSE
3
Touch and hold until the LED counts down "3-2-1" and the
dryer starts, or touch once while a cycle is in process to
pause it.
LED DISPLAY AND SETTINGS
4
When you select a cycle, its settings will light up and the
Estimated Cycle Time (for Sensor Cycles) or actual time
remaining (for Timed Cycles) will be displayed.
See "Cycle Guide" for available settings on each cycle.
Not all settings are available with all cycles.
More Time/Less Time
Touch MORE TIME or LESS TIME with Timed Cycles
to increase or decrease the length of a Timed Dry
or Quick Dry cycle.
Temp
When using any cycle except Sanitize, you may select
a dry temperature based on the type of load you are
drying. Use the warmest setting safe for the garments
in the load. Follow garment label instructions.
Dryness
When using Sensor Cycles (except for the Sanitize
cycle), you may select a Dryness level based on the
type of load you are drying.
NOTE: Dryness is for use with Sensor Cycles only.
6
2
E XT R A POWE R
OPTIONS
5
Use to select available options for your dryer. Not all cycles
and options are available on all models.
Wrinkle Prevent
If you will be unable to remove a load immediately,
touch WRINKLE PREVENT to add up to 150 minutes
of periodic tumbling to help reduce wrinkling. On steam
models, on some cycles, you may select the "+Steam"
setting to add a short steam cycle after 60 minutes
to help smooth out wrinkles.
Reduce Static
Touch to add the Reduce Static option to selected
Sensor Cycles (see "Cycle Guide"). The dryer will
automatically tumble, pause, and introduce a small amount
of moisture into the load to help reduce static. This option
adds approximately 3 minutes to the total cycle time.
Steam
Steam adds steam to the end of certain Sensor Cycles
to help smooth wrinkles. It is not available on Sanitize,
Delicates, Steam Refresh, or Timed Cycles (Timed Dry,
Quick Dry). Steam can be used with High, Medium High,
or Medium heat settings. This option adds approximately
15 minutes to the total cycle time.
Cycle Signal
Use this to turn the signal indicating the end of a drying
cycle on or off. Touch and hold REDUCE STATIC for
3 seconds to turn sounds on or off.
Control Lock
Use to lock the controls of the dryer and avoid
an accidental change in cycle options or preferences
during a drying cycle. Touch and hold STEAM for
3 seconds to lock or unlock the controls of the dryer.
During this time, the LED Display will count down "3-2-1. "
Once the controls are locked, the Control Lock icon
will illuminate.
NOTE: The Control Lock function may be enabled when
recovering from a power failure. To unlock the control,
touch and hold STEAM for at least 3 seconds.
Extra Power
The Extra Power option can be used with both Sensor
and Timed Dry Cycles. Press the Cycle Control Knob
to activate the Extra Power option, which provides an
additional 10 minutes of cycle time (including additional
heat and tumbling, where applicable). When Extra Power
is activated, the Cycle Control Knob will illuminate and
the estimated time remaining on the display will show an
additional 10 minutes.
4
6 5
5
1
3 7