Maytag W11204389A Guide D'utilisation Et D'entretien page 9

CYCLE GUIDE — TIMED CYCLES
Settings and options shown in bold are default settings for that cycle.
If settings are changed, the new settings will be remembered (except on Quick Dry). If there is a power failure, settings will return
to the default.
Not all features and cycles are available on all models.
Not all settings and options are available on each cycle.
Adjusting drying time on Timed Cycles
When you select a Timed
Cycle, the time appears in
the display. Use More Time
and Less Time to increase
or decrease the time
in 5-minute increments.
The maximum dry time
is 150 minutes.
Cycle:
Items to dry:
Any load Timed Dry
NOTE: Select
AirDry to dry foam,
rubber, plastic,
or heat-sensitive
fabrics.
Small loads Quick Dry
and sportswear
On steam models, you may select the "+Steam" setting to add a short steam cycle after 60 minutes. This is available only with High, Medium High, and
†
Medium drying temperature settings.
CYCLE GUIDE — STEAM CYCLE (on some models)
Settings and options shown in bold are default settings for that cycle.
Not all settings and options are available on each cycle.
Steam cycles are designed for use with dry loads to loosen wrinkles, reduce odors, and refresh fabrics.
Items
Cycle:
to refresh:
Shirts, blouses, Steam Refresh
and slacks
Load Size Recommendations
For best results, follow the load size recommendations noted
for each cycle.
Small load: Fill the dryer drum with 3–4 items, not more
than 1/4 full.
NOTE: Government energy certifi cations for this model were based on the Normal Cycle, Highest Temperature Setting, Normal Dryness
Level. The as-shipped defaults were the same as the Government Energy Certifi cation Settings except the Default Temperature Setting
of Medium High was adjusted to the Highest Temperature Setting.
Drying Default
Temperature:
Time:
High 0:40
Medium High
Medium
Low
AirDry
High 0:15
Medium High
Medium
Low
AirDry
Drying
Default
Temperature: Time:
High 0:20
Medium High
Selecting the Drying Temperature
A High heat setting may be used for drying heavyweight items
such as towels and work clothes.
A Low to Medium heat setting may be used for drying
mediumweight items such as sheets, blouses, dresses,
underwear, permanent press fabrics, and some knits.
Use a no heat (AirDry) setting for foam, rubber, plastic,
or heat-sensitive fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures
for various loads, refer to the care label directions.
Available
Options:
Wrinkle Prevent Use to dry items to a damp level for items that do
†
Extra Power not require an entire drying cycle. Select a drying
temperature based on the type of fabrics in your
load. If you are unsure of the temperature to select
for a load, select the lower setting rather than the
higher setting.
Wrinkle Prevent For small loads of 3–4 items.
†
Available
Options:
Wrinkle Prevent Use to reduce light wrinkles from loads left in the
dryer too long. Do not add dryer sheets.
Medium load: Fill the dryer drum up to about 1/2 full.
Large load: Fill the dryer drum up to about 3/4 full.
Do not overload. Items need to tumble freely.
Cycle Details:
Cycle Details:
9