Use With An External Dmx Controller - Renkforce 1488543 Notice D'emploi

Menu Item Option
dISP dISP
dSIP
PInt no
YeS
tInt no
YeS
bALA red
Gee
bLu
NAnu PAn
tILt
ZooN
red
Gee
bLu
Uhi
dINN
Stro
teSt
rSet U402
b) Use with an external DMX controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds. The
remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires 10, 12 or 15 free DMX channels depending on the operating mode.
Setting the DMX starting address
• Use the MENU button to select addr in the menu and push the ENTER button.
• Select the desired starting address 1-512 with the UP and DOWN buttons.
• Press the ENTER button to confirm your selection.
Setting the DMX channel number
• Use the MENU button to select ChNd in the menu and push the ENTER button.
• Select the desired DMX channel number (10, 12 or 15) with the UP and DOWN buttons.
• Press the ENTER button to confirm your selection.
30
Function
Display alignment normal
Display alignment inverted
PAN-movement not inverted
PAN-movement inverted
TILT-movement not inverted
TILT-movement inverted
White reconciliation red share 125-255
White reconciliation green share 125-255
White reconciliation blue share 125-255
Manual setting of the PAN-position
Manual setting of the TILT-position
Manual setting of the zoom function
Manual brightness change for red colour
Manual brightness change for green colour
Manual brightness change for blue colour
Manual brightness change for white colour
Manual setting total brightness
Manual setting strobe speed
Self-test function
Performing a reset