Use With An External Dmx Controller - Renkforce 1284227 Mode D'emploi

l) Use with an External DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires 1-7 free DMX channels depending on DMX operating mode.
DMX operation always takes precedence over any other mode. Once a signal is pending at the
DMX input DMX IN, the other operating modes are deactivated. The display shows the DMX
starting address.
Setting the DMX starting address
• Set the desired DMX starting address (001-512) in the menu Addr.
Setting the DMX operating mode
• Set the desired number of DMX channels in the menu ChNd (1Ch-7Ch).
The following tables provide information about the effects of the settings on the individual DMX channels.
1-channel DMX operation
DMX channel Value
1 000-255
2-channel DMX operation
DMX channel Value
1 000-255
2 000-255
3-channel DMX operation
DMX channel Value
1 000-255
2 000-255
3 000-255
4-channel DMX operation
DMX channel Value
1 000-255
2 000-255
3 000-255
4 000-255
Function
29 different colour pre-settings (see table 1)
Function
29 different colour pre-settings (see table 1)
Total brightness 0-100%
Function
Brightness red 0-100%
Brightness green 0-100%
Brightness blue 0-100%
Function
Brightness red 0-100%
Brightness green 0-100%
Brightness blue 0-100%
Total brightness 0-100%
37