Advanced Setup - Yamaha HTR-6295 Mode D'emploi

In the advanced setup menu, you can set basic operations
of this unit, such as on and off of a bi-amp connection, or
initialize user settings.
1
Set this unit to standby.
2
While holding down QSTRAIGHT on the
front panel, press LMAIN ZONE ON/OFF.
Keep holding down QSTRAIGHT until
"ADVANCED SETUP" appears on the front panel
display.

ADVANCED SETUP

3
Rotate the PPROGRAM selector to select
the parameter you want to change.
The default setting are marked with "*".
y
• Set values are placed in XXX of the following parameters on an
actual display screen.
SP IMP. -XXX
Choices:
6ΩMIN, 8ΩMIN*
Selects output impedance of this unit according to
connected speakers. When you connect 4-ohm
speakers to the FRONT speaker terminals, set "SP
IMP." to "6ΩMIN.".
RS232C STBY -X
Choices:
Y (Yes), N (No)*
Selects whether or not to transmit data via the RS-
232C terminal when this unit is in the standby mode.
REMOTE ID -XXX
Choices:
ID1*, ID2
Sets a remote control ID. When using multiple
Yamaha AV receivers, you can operate them with a
single remote control by setting the receiver IDs to
the same setting.
BI AMP - XXX
Choices:
ON, OFF*
Switches on and off of bi-amp connection of main
speakers. For bi-amp connection, see page 12.
SCENE IR -XXX
Choices: ON*, OFF
Selects whether or not to transmit the control signals
to an external component connected to the REMOTE
OUT jack on this unit when BD/DVD or CD SCENE
function is selected.
MON.CHK - XXXX
Choices:
YES*, SKIP
Adds upscaling limitation on output signals to a video
monitor connected to this unit via the HDMI OUT
jack.
60
En
Advanced setup
INIT-XXXXXXXXX
Choices:
Initializes various settings stored in this unit. You can
select an initialization method from the following.
DSP PARAM All parameters of sound field
VIDEO
NETWORK Network settings in the Setup menu
ALL
CANCEL
USB FirmUpdate
NET FirmUpdate
Updates the firmware of this unit. For details on how
to update the firmware, refer to information supplied
with updates.
Notes
• Do not use this feature unless you need to update the firmware.
• Be sure to read information supplied with updates before updating
the firmware.
VERXXX.XXX.XXX
Displays the firmware of this unit.
4
Press OSTRAIGHT repeatedly to change
the selected parameter setting.
To change other settings, repeat steps 3 and 4.
5
Press KMAIN ZONE ON/OFF to set this
unit to standby.
The settings you made are reflected next time you
turn on this unit.
DSP PARAM, VIDEO, NETWORK, ALL,
CANCEL*
programs
Video conversion settings (resolution/
aspect) in the Setup menu and the GUI
display position
All
Cancellation of initialization