Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
■
Notes on remote controls and batteries
•
Do not spill water or other liquids on the remote control.
•
Do not drop the remote control.
•
Do not leave or store the remote control in the following
conditions:
– places of high humidity, such as near a bath
– places of high temperatures, such as near a heater or stove
– places of extremely low temperatures
– dusty places
•
Insert the battery according to the polarity markings (+ and -).
•
Change all batteries if you notice the following conditions:
– the operation range of the remote control narrows
– the transmit indicator does not flash or is dim
•
If the batteries run out, immediately remove them from the
remote control to prevent an explosion or acid leak.
•
If you find leaking batteries, discard the batteries
immediately, taking care not to touch the leaked material. If
the leaked material comes into contact with your skin or gets
into your eyes or mouth, rinse it away immediately and
consult a doctor. Clean the battery compartment thoroughly
before installing new batteries.
•
Do not use old batteries together with new ones. This may
shorten the life of the new batteries or cause old batteries to
leak.
•
Do not use different types of batteries (such as alkaline and
manganese batteries) together. Specification of batteries may
be different even though they look the same.
•
Before inserting new batteries, wipe the compartment clean.
•
If the remote control is without batteries for more than 2
minutes, or if exhausted batteries remain in the remote
control, the contents of the memory may be cleared. In such a
case, install new batteries and set the remote control code.
•
Dispose of batteries according to your regional regulations.
Caution-iii
En
Publicité
Table des Matières
