Sony STR-DA5400ES Mode D'emploi page 97

Operating the receiver from
zone 3
1
Turn on the main receiver (this
receiver) and the amplifier in
zone 3.
2
Press ZONE.
The remote switches to zone 3. Change
the zone setting of the remote to zone 3 in
advance (page 95).
3
Press ?/1.
The zone function is activated.
4
Press one of the input buttons
on the remote to select the
source signals you want to
output.
For zone 3, only analog audio signals are
output. When you select SOURCE, the
signals of the current input are output.
5
Adjust to a suitable volume
using the receiver in zone 3.
To finish the zone 3 operation
Press ?/1 after pressing ZONE.
Tips
• Even when this receiver is standby mode (press
?/1 on the remote to turned off this receiver), the
receiver in zone 2 or zone 3 remains turned on. To
turn off all receivers, press ?/1 and AV ?/1 on the
main remote at the same time (SYSTEM
STANDBY).
• Only signals from components connected to the
analog input jacks are output through the ZONE 2
or ZONE 3 jacks. No signals are output from
components connected to only the digital input
jacks.
• When SOURCE is selected, the signals input to the
MULTI CHANNEL INPUT jacks are not output
from the ZONE 2 OUT or ZONE 3 OUT jacks
even when the multi-channel input is selected. The
analog audio signals of the current function are
output.
97 GB