Connect The Conductivity Electrode; Meter Stand For Adjusting View Angle; Attached Quick Guide - OHAUS STARTER 3100C Manuel D'instructions

STARTER 3100C Bench Conductivity Meter
2.4

Connect the conductivity electrode

There is one socket "COND." for conductivity electrode.
2.5

Meter stand for adjusting view angle

One unique design of the STARTER 3100C is the meter stand, which can be used to adjust the view
angle of the display in case of working on high lab table.
2.6

Attached quick guide

Another unique design of the STARTER 3100C is the attached quick guide, the quick guide is
attached into the bottom housing of the meter, you can use finger to pull it out.
EN-7