Applicable Controls - Toshiba RAV-SM564UT-E Manuel D'installation

+00EH99858901_01EN_4-way_IM_printOnly.book Page 21 Tuesday, December 4, 2007 2:31 PM
4-way Air Discharge Cassette Type
8

APPLICABLE CONTROLS

REQUIREMENT
• When you use this air conditioner for the first
time, it takes approx. 5 minutes until the
remote controller becomes available after
power-on. This is normal.
<When power is turned on for the first time
after installation>
It takes approx. 5 minutes until the remote
controller becomes available.
"SETTING"
Power
on flashes
<When power is turned on for the second
(or later) time>
It takes approx. 1 minute until the remote
controller becomes available.
"SETTING"
Power
on flashes
• Normal settings were made when the indoor
unit was shipped from factory.
Change the indoor unit settings as required.
• Use the wired remote controller to change the
settings.
* The settings cannot be changed using the
wireless remote controller, sub remote
controller, or remote-controllerless system
(for central remote controller only).
Therefore, install the wired remote controller
to change the settings.
21-EN
Approx. 5 minutes
"SETTING" Remote
goes out controller
is available
Approx. 1 minutes
"SETTING" Remote
goes out controller
is available
– 21 –
„ Changing of settings of for
applicable controls
Basic procedure for changing settings
Change the settings while the air conditioner is not
working.
(Be sure to stop the air conditioner before making
settings.)
4
6
1 5 2
1
Procedure
Push button and temp. setup
simultaneously for at least 4 seconds.
After a while, the display flashes as shown in the
figure.
Confirm that the CODE No. is [01].
• If the CODE No. is not [01], push
erase the display content, and repeat the
procedure from the beginning.
(No operation of the remote controller is
accepted for a while after
(* Display content varies with
the indoor unit model.)
2
Procedure
Each time you push button, indoor unit
numbers in the control group change cyclically.
Select the indoor unit you want to change settings
for.
The fan of the selected unit runs and the louvers
start swinging. You can confirm the indoor unit for
which you want to change settings.
Installation Manual
1
3
button
button to
button is pushed.)
Toshiba XXXXXXX(X/X)