Clearing Custom Programming; Important; Activating Backlighting (Optional) - Universal Electronics ATLAS OCAP Guide D'utilisation

Atlas OCAP M1056.fm Page 22 Tuesday, March 24, 2009 4:45 PM

CLEARING CUSTOM PROGRAMMING

The Atlas OCAP 5-Device Remote Control contains a
Custom Programming Reset program. You can use it to
remove all custom programming, except your setup
codes and reassigned device keys.
IMPORTANT: Executing this program will erase all cus-
tom settings for Volume Lock, Learned Keys,
Tune-In Keys, and Channel Lock. However,
your device programming remains.
1. On the remote control, press and hold SETUP
until the last-selected device key blinks twice.
2. Enter 9 8 0. The last-selected device key
blinks twice, pauses, and blinks twice again to
confirm that all custom programming is
cleared.

ACTIVATING BACKLIGHTING (OPTIONAL)

On some models of your Atlas OCAP 5-Device Remote
Control, you can activate backlighting. Backlighting
enables your remote's keypad to remain lit for five
seconds after you press any key. To enable backlighting
on a remote with that feature, perform the following
step:
1. Press SETUP twice within one second.
Backlighting is turned on.
To disable backlighting, perform the following step:
1. Press SETUP twice within one second.
Backlighting is turned off.
www.urcsupport.com/atlasocap
22