Using The Master Power Key; Clearing The Master Power Key; Re-Assigning Device Keys - Universal Electronics ATLAS OCAP Guide D'utilisation

Atlas OCAP M1056.fm Page 20 Tuesday, March 24, 2009 4:45 PM

Using the Master Power Key

1. After programming, point the remote control
at the devices. Press CBL once.
2. Press PWR once to sequentially turn the
programmed home entertainment devices on
or off.
You will see the devices turn on or off according to the
programmed sequence.

Clearing the Master Power Key

1. On the remote control, press and hold SETUP
until the last-selected device key blinks twice.
2. Enter 9 9 5. The last-selected device key
blinks twice.
3. Press and release PWR.
4. Press and hold SETUP until the CBL key blinks
twice.

RE-ASSIGNING DEVICE KEYS

The Atlas OCAP 5-Device Remote Control can be set up
to control a second device of an already-assigned type.
For example, to have the unit control a TV, a Cable
Converter, and two audio devices (for example, two
audio receivers), re-assign the unused VCR key to
operate the second audio device as follows:
NOTE: VCR is preset at the factory to control an RCA
VCR. Performing the steps below will over-
write those settings.
1. On the remote control, press VCR once; it will
blink once. Then press and hold SETUP until
the VCR key blinks twice.
2. Enter 9 9 2. The VCR key will blink twice.
www.urcsupport.com/atlasocap
20