Checking The Codes - Universal Electronics ATLAS OCAP Guide D'utilisation

Atlas OCAP M1056.fm Page 13 Tuesday, March 24, 2009 4:45 PM
4. Aim the remote control at the TV and press
PWR once.
5. Press and release the CH+ key continuously,
then stop when the TV turns off.
NOTE: In the search mode, the remote control will
send IR codes from its library to the selected
device, starting with the most popular code
first.
6. Press PWR. The TV should turn on, then press
SETUP to lock in the code.
NOTE: If the TV does not turn on during step 6, then
slowly press and release CH- to go back
through the codes, then press SETUP when the
TV turns on.
7. To search for the codes of your other devices,
repeat steps 1 through 6, but substitute the
appropriate key (e.g., VCR, DVD, AUD, or CBL)
for the device you are searching for.

CHECKING THE CODES

If you have set up the Atlas OCAP 5-Device Remote
Control by searching for your device code (on the
previous page), you may need to find out which four-
digit code is operating your equipment.
For example, to find out which code is operating your TV:
On the remote control, press TV once; it will
1.
blink once. Then press and hold SETUP until
the TV key blinks twice.
2. Enter 9 9 0. The TV key will blink twice.
3. To view the code for the first digit, press 1
once. Count the number of times the TV key
blinks (e.g., 3 blinks = 3) and write down the
number in the leftmost TV Code box on
page 11.
NOTE: If a code digit is 0, the selected mode key will
not blink.
www.urcsupport.com/atlasocap
13