Changing Volume Lock; Unlocking Volume Control For A Single Device (Individual Volume Unlock) - Universal Electronics ATLAS OCAP Guide D'utilisation

Atlas OCAP M1056.fm Page 15 Tuesday, March 24, 2009 4:45 PM
3. Press CH+ once. The CBL key will blink twice.
Now, regardless of what mode you select (except AUD),
the channel keys will only change channels on your cable
converter.

CHANGING VOLUME LOCK

Volume Lock allows you to control the volume through
the device identified as having your primary speaker(s),
regardless of which mode you are using. On the Atlas
OCAP 5-Device Remote Control, Global Volume Lock is
set to TV, so you can control TV volume while in the VCR,
DVD, TV or CBL mode. You can perform Individual
Volume Unlock on a selected device to set its volume
control for independent operation.
NOTE: The audio mode's (AUD) volume controls are
active regardless of Volume Lock settings.
However, if you lock the volume controls to
the AUD mode, you will have control of the
audio device's volume in all other modes (i.e.,
VCR, DVD, TV, and CBL). This can be an advan-
tage if, for example, you always listen to home
entertainment devices through your receiver's
speakers.
Unlocking Volume Control for a Single Device
(Individual Volume Unlock)
1. Assuming Global Volume Lock is active, select
a mode on the remote control that you want to
unlock (e.g., CBL) and press it once. Next,
press and hold SETUP until the device key
blinks twice.
2. Enter 9 9 3. The last-selected device key will
blink twice.
Press VOL- once. The last-selected device key
3.
will blink four times.
4. Repeat steps 1 through 3 for each device you
want volume to be unlocked.
Now, after you select a device that has volume unlocked
(e.g., CBL), pressing VOL+, VOL-,or MUTE, will control
only that device's volume.
www.urcsupport.com/atlasocap
15