Grounding And Ac Power Cord Connections; Mounting Instructions - Schumacher Electric SE-1-12S Guide D'utilisation

8.

GROUNdiNG ANd AC POWER CORd CONNECTiONS

The plug pins must fit the receptacle (outlet). Do not use with an
ungrounded system.
8.2
does not fit the outlet, have a proper grounded outlet installed by
a qualified electrician. An improper connection can result in a risk
of an electric shock or electrocution. NOTE: Pursuant to Canadian
Regulations, use of an adapter plug is not allowed in Canada.
Use of an adapter plug in the United States is not recommended
and should not be used.
8.3 Recommended minimum AWG size for extension cord:
• 150 feet (45.7 meters) long or less – use an 18 gauge (0.82 mm
extension cord.
9.

MOUNTiNG iNSTRUCTiONS

Mounting the charger to the fender well: The
charger can be mounted directly to the fender well
of your vehicle as shown. If using the nuts and bolts
provided, drill two holes between 3/16" and 1/4" in
diameter. (For alignment of holes use the charger as
a template.) If the backside of the mounting surface
is hard to reach, you may consider using two 1/2" long sheet metal
screws (not included) instead of the nuts and bolts provided.
Mounting the charger alongside the battery:
The charger can also be mounted alongside your
vehicle's battery using the
bracket provided. If possible,
mount the charger to the
side of the battery away
from the engine and fan
blades. Mount the bracket
RiSK OF ELECTRiC SHOCK OR FiRE.
8.1 This battery charger is for use on
a nominal 120-volt circuit. The plug must
be plugged into an outlet that is properly
installed and grounded in accordance
with all local codes and ordinances.
Never alter the AC cord or plug provided – if it
• 8 •
)
2