Russell Hobbs 23300 Mode D'emploi page 5

DRY IRONING
1. If you're going to be dry ironing for 20 minutes or more, empty the reservoir first, to avoid
spontaneous bursts of steam.
2. Set the steam control to n.
3. Set the desired temperature.
4. When the smart status light flashes green your iron is ready to use.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
• Check that there's adequate ventilation behind the fabric, otherwise moisture may build
up, causing mildew.
• Check that there's nothing behind the fabric that may be damaged by the steam.
• Check that pockets, turn-ups, and cuffs are empty.
• Check that there's water in the reservoir.
1. Set the temperature control to max.
2. Hold the iron close to (but not touching) the fabric.
3. Press the hbutton (you're using the "shot of steam" function vertically).
4. Leave 4 seconds between shots, to let the temperature build up.
AFTER USE
1. Set the temperature control to •.
2. Unplug the stand.
3. Open the water inlet cover.
4. Hold the iron over a sink, turn it upside down, and drain the water from the reservoir.
5. Sit the iron on the base and leave it to cool down completely.
6. When cold, wipe off any moisture, and close the water inlet cover.
7. Wipe outer surfaces with a damp cloth.
8. Remove spots from the soleplate with a little vinegar – take care not to scratch it.
SELF CLEAN
To avoid scale build up, use the self clean function at least monthly in normal water areas, more
often in hard water areas.
You'll need a basin or a large bowl to catch the water coming out of the soleplate.
1. Fill the reservoir to the max mark.
2. Set the temperature control to max.
3. Sit the iron on the stand.
4. Plug in the stand and wait till the smart status light flashes green.
5. Hold the iron over the basin or bowl with the soleplate down.
6. Move the steam control past n to C and hold it there.
7. Gently move the iron to and fro, over the basin or bowl.
8. Water and steam will wash scale and dust through the soleplate, and into the sink.
9. When water and steam stop coming from the soleplate, release the steam control.
AUTO SHUT-OFF
1. If the iron is motionless for about 8 minutes it will switch off.
2. The smart status light will slowly pulse red.
3. To switch on again, lift it off the stand then return it and allow it to heat up again until the
smart status light flashes green.
W
ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous substances in electrical
and electronic goods, appliances marked with this symbol mustn't be disposed of with
unsorted municipal waste, but recovered, reused, or recycled.
5