Fein ASW18-6 PC Serie Mode D'emploi page 6

OBJ_BUCH-0000000390-001.book Page 6 Wednesday, June 12, 2019 7:40 AM
en
6
When battery fluid from a damaged battery
has come into contact with objects close by,
check the respective components, clean them
or replace them as required.
Keep the battery away from heat and fire. Do
not store the battery in direct sunlight.
Do not remove the battery from its original
packaging until it is going to be used.
Before any work on the machine itself,
remove the battery from the power tool. If the
power tool accidentally starts, there is danger
of injury.
Mount the battery only when the power tool is
switched off.
Hand/arm vibrations.
While working with this power
WARNING
tool, hand/arm vibrations
occur. These can lead to health impairments.
The vibration emission value
WARNING
during actual use of the power
tool can differ from the declared value
depending on the ways in which the tool is
used.
It is necessary to identify
WARNING
safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use.
The vibration emission level given in this
information sheet has been measured in
accordance with a standardized test given in
EN 62841 and may be used to compare one
tool with another. It may be used for a pre-
liminary assessment of the vibrational impact.
The declared vibration emission level repre-
Remove the battery only when the power tool
is switched off.
Keep the battery away from children.
Keep the battery clean and protect it against
moisture and water. Clean contaminated bat-
tery terminals and power tool connections
with a dry, clean cloth.
Use only intact original FEIN batteries that are
intended for your power tool. When working
with and charging incorrect, damaged,
repaired or reconditioned batteries, imita-
tions or other brands, there is danger of fire
and/or explosion.
Follow the safety warnings in the operating
instructions of the battery charger.
sents the main applications of the power tool.
However, if the power tool is used for other
applications with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly increase the
vibrational impact over the total working
period.
An estimation of the level of exposure to
vibration should also take into account the
times when the tool is switched off or when
it is running but not actually doing the job.
This may significantly reduce the vibrational
load over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration
such as: Maintain the power tool and the
accessories, keep the hands warm, organiza-
tion of work patterns.