Fein ASW18-6 PC Serie Mode D'emploi page 22

OBJ_BUCH-0000000390-001.book Page 22 Wednesday, June 12, 2019 7:40 AM
en
22
Adjustments.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Setting the torque (figure 11).
Before putting the power tool into operation
for the first time, the torque of the mechanical
shut-off clutch must be set to the desired
value within the permissible test range and
checked using a suitable dynamic measuring
system.
Open the cover using a screwdriver.
Turn the tool holder until the hole can be
seen under the cover.
Adjust the desired torque with the torque
setting tool.
Turn in the direction of the "+" to increase
the torque.
Turn in the direction of the "–" to reduce the
torque.
Shut the cover again.
Fig. 11
2.
3.
4.
5.
1.