Fein ASW18-6 PC Serie Mode D'emploi page 19

OBJ_BUCH-0000000390-001.book Page 19 Wednesday, June 12, 2019 7:40 AM
Mounting the angle head (ASW 18-18 PC (**)/ASW 18-30 PC (**)/
ASW 18-45 PC (**)/ASW 18-60 PC (**)) (figure 8).
Loosen the clamping sleeve with the hook
wrench and remove it.
Clean the threaded surface with a soft cloth
and a degreasing solvent. Apply retaining
compound to the threads.
Pay attention that the threads are grease-
free before applying the retaining com-
pound.
Fig. 8
1.
Clamping sleeve
2.
4.
Angle head
Slide the clamping sleeve onto the angle head
and then fasten the securing ring.
Place the angle head onto the machine inter-
face and secure it by screwing the clamping
sleeve clockwise using the hook spanner.
Additional information: Further information
on replacement of the output can be found
on the Internet under www.fein.com.
ASW 18-30 PC
ASW 18-45 PC
ASW 18-60 PC
Hook spanner
3.
Securing ring
5.
10.
ASW 18-18 PC
6.
8.
7.
M = 15-20 Nm
24
en
19
6.
9.