Fein ASW18-6 PC Serie Mode D'emploi page 20

OBJ_BUCH-0000000390-001.book Page 20 Wednesday, June 12, 2019 7:40 AM
en
20
Mounting the extension (ASW 18-30 PC (**)/ASW 18-45 PC (**)/
ASW 18-60 PC (**)) (optional accessory) (figure 9).
Loosen the clamping sleeve with the hook
wrench and remove the angle head.
Fasten the motor-shaft extension.
Mount the extension and lock it using the
hook wrench.
Slide the locking sleeve into the extension
and mount the connector onto the motor-
shaft extension.
Clean the threaded surface with a soft cloth
and a degreasing solvent. Apply retaining
compound to the threads.
Fig. 9
1.
2.
Angle head
3.
Motor-shaft extension
4.
6.
7.
Extension
Clamping sleeve
Hook spanner
5.
M = 15-20 Nm
Pay attention that the threads are grease-
free before applying the retaining com-
pound.
Mount the angle head onto the extension and
lock the clamping sleeve using the hook
wrench.
Additional information: Further information
on replacement of the output can be found
on the Internet under www.fein.com.
8.
Locking sleeve
3/8"
9.
1/2"
9.
Connector
11.
9.
10.