Electrical Connection - Whirlpool ACM 406 Mode D'emploi

ELECTRICAL CONNECTION

The electrical connection must be carried
out in accordance with the current
standards and laws in force.
Before connecting check that:
• The system and electrical sockets amperage
is adequate for the appliance maximum
power (see data label affixed on the back of
the cooker).
• The socket or system has an effective earth
connection in accordance with current
standards and prescriptions of the law. All
responsibility is disclaimed if this is not
complied with.
• The plug and socket or the multipolar switch
must be accessible after installation of the
appliance.
• If the appliance has no power cable,
connect one with a suitable cross section
to the terminal board (see paragraph
«CONNECTING THE POWER CABLE»).
When connecting to the mains with a socket:
• Fit to the power cable (if without) a
standardized plug, suitable for the load
which is indicated on the data label. Connect
the wires making sure they correspond as
shown below, and remember that the earth
wire must be longer than the phase wires:
L
letter (phase)
N
letter (neutral)
symbol (earth)
• The power cable must be laid so that no parts
of it ever reach a temperature of 75 °C.
• For connecting do not use, adapters or
shunts as they could cause false contacts
resulting in hazardous overheating.
When connecting directly to the mains:
• Install a multipolar switch that can withstand
the appliance load, with a minimum opening
between the contacts of 3 mm.
• Remember that the earth wire must not be
cut out by the switch.
INSTRUCTIONS FOR THE INSTALLER
= brown wire
= blue wire
= green/yellow wire
CONNECTING THE POWER CABLE
The all-electric cookers and some combi
versions leave the factory ready for single-
phase power, butt they can, with due
modifications, be powered by three phase
systems by following these instructions:
• Remove the rear panel from the cooker.
• Move the connecting plates in the terminal
board according to the type of connection
you want, following the diagram in fig. 18.
You will also find this diagram affixed to the
back of the cooker.
• Connect the power cable, whose cross
section must be suitable on TECHNICAL
FEATURES paragraph, keeping the earth wire
longer than the phase wires.
• Secure the cable in the clamp and - fit the
rear panel in place.
240 V 240 V 3
29
18
415 V 3N
415 V 2N