Cleaning; Stroage Instructions - IKRA BRM 1446 S Manuel D'utilisation

To remove the blade, unscrew the screw, check the blade
support and change all spare parts if they are worn out
or damaged.
When reassembling the blade, make sure that the
cutting edges face in the direction of the engine rotation.
The blade screw must be torque to 3.7 Kgm (37Nm) with
a dynamometric tool.
ONLY USE ORIGINAL SPARE PARTS. SPARE
PART OF BAD QUALITY CAN INVOLVE IMPORTANT
DAMAGES TO YOUR LAWNMOWER AND BEPREJU-
DICIAL FOR YOUR SECURITY.

3.1 CLEANING

CAUTION: Do not hose engine. Water can damage
engine or contaminate the fuel system.
1. Wipe deck with dry cloth.
2. Hose under deck by tilting the mower so that the
spark plug is up.
3. Refer to separate engine manual for engine cleaning
instructions.
GB | Operating Instruction

3.2 STROAGE INSTRUCTIONS

The following steps should be taken to prepare lawn mo-
wer for storage.
1. Following the final cut of the season allow the fuel
2. Clean and lubricate mower thoroughly as described in
3. Refer to engine manual for correct engine storage
4. Lightly coat mower's cutting blade with chassis grea-
5. Store mower in a dry, clean area.
• When storing any type of power equipment in an un-
ventilated or material storageshed.
• Care should be taken to rust-proof the equipment.
Using a light oil or silicone,coat the equipment, espe-
cially cables and all moving parts.
• Be careful not to bend or kink cables.
• If the starter rope becomes disconnected from rope
guide on handle, disconnect and ground the spark
plug wire, Depress the blade control handle and pull
the starter rope out from engine slowly. Slip the starter
rope into the rope guide bolt on handle.
8
tank to run dry.
the lubrication instructions.
instructions.
se to prevent rusting.
NOTE: