Maintenance; General Maintenance; Troubleshooting - Skil PWRCORE 20 ID6739B-00 Guide D'utilisation

MAINTENANCE

WARNING
Service
WARNING
cause a serious hazard . We recommend that all tool service be performed by a SKIL Factory
Service Center or Authorized SKIL Service Station.

General Maintenance

WARNING
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced. Please contact customer service an
authorized service center for assistance.
Cleaning
WARNING
air . Ventilation openings and switch levers must be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed objected through openings.
WARNING
ammonia and household detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.

TROUBLESHOOTING

Problem
Tool does not work.
LED light rapidly
flashes
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance .
Preventive maintenance performed by unauthorized personal may
result in misplacing of internal wires and components which could
When servicing, use only identical replacement parts . Use of any
other parts could create a hazard or cause product damage .
The tool may be cleaned most effectively with compressed dry air .
Always wear safety goggles when cleaning tools with compressed
Certain cleaning agents and solvents damage plastic parts . Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
Cause
1. Battery pack charge is
depleted.
2. Tool is over-loaded.
3. Battery pack is too hot.
4. Battery pack is not installed
properly.
5. Burned out switch.
1. Tool is over-loaded.
2. Tool is too hot.
Remedy
1. Charge the battery pack.
2. Turn off the tool and then try again.
3. Turn off the tool and allow the
battery pack to cool under air flow.
4. Confirm that the battery pack is
locked and secured to the tool.
5. Have the switch replaced by an
Authorized SKIL Service Center or
Service Station.
1. Release the trigger switch.
2. Cool the tool under air flow.
17