Weston 86-0501-W Mode D'emploi page 7

STUFFER ASSEMBLY
5. Attach the Handle by sliding it
onto the Gear Shaft and placing
FIGURE 4
the Wingnut into the hole in
the Handle. Twist to tighten
(FIGURE 4).
6. Crank the Handle counter-
Gear Shaft
clockwise to bring the Plunger to
the top of the Stuffer.
Handle
7. Slide the Notches at the bottom
of the canister into the Canister
Mounts at the base of the Frame
(FIGURE 5).
Wingnut
8. Insert the Stuffing Funnel of
your choice through the Front
Ring Nut. Screw the Front Ring
Nut and Stuffing Funnel onto the
mouth of the Canister until snug.
DO NOT OVERTIGHTEN the
Front Ring Nut, as it may damage
the Funnel (FIGURE 6).
FIGURE 5
FIGURE 6
Notch
Mouth of the Canister
Front
Funnel
Ring Nut
7