Publicité
Les langues disponibles
Les langues disponibles
3
ITEM(S) NEEDED
f.
Detach the Removable Base from the rest of the
bracket by sliding it apart from the Non-removable
Base. If the installation will include the Removable
Base, align it with the holes that were drilled. If it
will not be used, set it aside and place the bracket
on the deck of the boat aligned with the drilled
holes.
g.
Take the four Phillips Pan Head Screws (Item #24)
and place one each in the hole of the selected
base and into the drilled holes. Double check the
orientation and then secure to the Deck of the boat
with a #2 screwdriver.
4
h.
Screw the Nylon Hex Nut up to the top of the threads
on the Rod and then leave it in place. Remove the
Rod from the Swivel Base. Hold the Rod in place
next to the Swivel Base .
i.
Next stow the motor and determine how tall the Rod
on the bracket needs to be. There are 6 notches along
the top of the Rod that are used to adjust the height
of the Rod for support. Based on the configuration for
your installation, sections may need to be removed in
order to obtain the proper support height. One section
on the Rod equals approximately one inch.
j.
If the Rod for your installation needs to be cut
shorter, loosen the Knob at the top of the Rod until
the Body can pull free from the Rod.
k.
When cutting the Rod at least one notch on the Rod
must remain. Double check the intended position
of the cut before cutting and make sure that the
Rod is not cut too short. Once the position is
selected, use a hacksaw at one of the notches to
cut the Rod to the correct height. If the original cut
is too long, an additional section can always be cut
after testing the Rod.
4k
Do Not Cut
©2019 Johnson Outdoors Marine Electronics, Inc.
#24 x 4
Rod
Cut Location
Notch
Section
3f
Swivel Base
Plunger
Non-
removable
Base
Removable Base
3f
Non-
removable
Base
Inboard
Boat
Deck
Marking
Drill
Holes
Drill
Holes
4h
Hold Rod as
shown for
measurement
Rod
Nylon
Hex Nut
Swivel
Base
NOTICE:
When cutting the Rod at least one notch on the
Rod must remain. If unsure, leave the Rod longer, and cut
off fewer notches and test after each notch is removed
before finishing the installation, or have the bracket
installed by a qualified marine installer.
CAUTION
When cut to the proper length and adjusted correctly the
Stabilizer body will not interfere with normal stowing of the
motor. On Terrova and PowerDrive this device is not a substitute
for positioning the Depth Collar against the Steering Housing
and tightening it to guard against accidental deployment.
3f
Inboard
Marking
Removable
Drill Holes
Base
Boat Deck
Phillips
3g
Pan Head
Boat
Screw
Deck
Removable
Base
Body
4i
Knob
Ideal
placement
Control
of Body
Shaft
Head
Rod
Trolling Motor
fully stowed
Nylon
Hex Nut
Boat Deck
minnkotamotors.com | 3
Publicité
