Publicité
Les langues disponibles
Les langues disponibles
3.
The base of the bracket includes a Plunger that is used to adjust the Swivel Base of the bracket. The Swivel Base can be locked
into 7 positions by pulling out the Plunger and rotating it up to 180 degrees at 30 degree increments.
4.
Once a mounting location is selected, determine if the bracket will be mounted with or without the Removable Base. The
Removable Base is recommended if the bracket needs to be removed for boat covers, etc. Check for clearance at the selected
location to make sure that the bracket does not encounter any obstructions while it is in use or when it is rotated or folded down.
The Body that captures the Shaft can be rotated 360 degrees. Check for any additional obstructions such as a windshield or
existing boat accessory such as lights or cable routing. If the Removable Base is used for mounting, make sure that there is
enough clearance for the Non-removable Base to be slid apart and separated from it.
INSTALLATION
1
ITEM(S) NEEDED
a.
Review the mounting considerations at the
beginning of installation and select a mounting
location. Take the Bow Mount Stabilizer Bracket
(Item #A) and determine if it will be mounted with
the Removable Base and become familiar with how
the bracket operates.
b.
Once a mounting location and base are selected,
and with the bracket fully assembled, position the
bracket on the deck of the boat as it is intended to
be used. Take an Awl or similar marking tool and
mark the location of the 4 mounting holes on the
deck of the boat. Also mark the perimeter of the
bracket with a pencil or marking tool.
2
c.
Take a scissors and cut out the mounting template.
It is located on the back of the card included in
the packaging. The Removable and Non-removable
Base use the same bolt pattern detailed on the
template.
d.
Note the orientation of the Plunger and set the
bracket aside. Place the template over the marked
location. Make sure the orientation of the template
matches the intended orientation of the bracket
and the marked location of the 4 mounting holes.
e.
Double check the alignment and then use a Drill
with a 9/64" drill bit to drill the 4 mounting holes
on the marked location. Then remove the template.
NOTICE:
Drill the holes for the screws completely
through to prevent splitting the boat deck.
©2019 Johnson Outdoors Marine Electronics, Inc.
#A x 1
1a
Cradle
Body
Strap
Knob
Rod
Nylon
Hex Nut
Non-
removable
Base
Swivel Base
Removable
Base
Plunger
2c
Drill
Holes
Location
of Plunger
2d
Inboard
Location
of Plunger
Markings
1b
Swivel Base
Plunger
Inboard
Markings
Template
Drill
Holes
Template
Markings
minnkotamotors.com | 2
Publicité
