Publicité
Les langues disponibles
Les langues disponibles
3
ITEM(S) NEEDED
f.
Detach the Removable Base from the rest of
the bracket by sliding it apart from the Non-
removable Base. If the installation will include
the Removable Base, align it with the holes that
were drilled. If it will not be used, set it aside and
place the bracket on the deck of the boat aligned
with the drilled holes.
g.
Take the four Phillips Pan Head Screws (Item
#24) and place one each in the hole of the
selected base and into the drilled holes. Double
check the orientation and then secure to the Deck
of the boat with a #2 screwdriver.
4
h.
Screw the Nylon Hex Nut up to the top of the
threads on the Rod and then leave it in place.
Remove the Rod from the Swivel Base. Hold the
Rod in place next to the Swivel Base .
i.
Next stow the motor and determine how tall the
Rod on the bracket needs to be. There are 6
notches along the top of the Rod that are used to
adjust the height of the Rod for support. Based on
the configuration for your installation, sections may
need to be removed in order to obtain the proper
support height. One section on the Rod equals
approximately one inch.
j.
If the Rod for your installation needs to be cut
shorter, loosen the Knob at the top of the Rod until
the Body can pull free from the Rod.
k.
When cutting the Rod at least one notch on the
Rod must remain. Double check the intended
position of the cut before cutting and make
sure that the Rod is not cut too short. Once the
position is selected, use a hacksaw at one of the
notches to cut the Rod to the correct height. If
the original cut is too long, an additional section
can always be cut after testing the Rod.
4k
Rod
Do Not Cut
©2019 Johnson Outdoors Marine Electronics, Inc.
#24 x 4
Cut Location
Notch
Section
3f
Swivel Base
Plunger
Non-
removable
Base
Removable Base
Non-
3f
removable
Base
Boat
Inboard
Deck
Marking
Drill
Holes
Drill
Holes
4h
Hold Rod as
shown for
measurement
Rod
Nylon
Hex Nut
Swivel
Base
NOTICE:
When cutting the Rod at least one notch on
the Rod must remain. If unsure, leave the Rod longer,
and cut off fewer notches and test after each notch is
removed before finishing the installation, or have the
bracket installed by a qualified marine installer.
CAUTION
When cut to the proper length and adjusted correctly the
Stabilizer body will not interfere with normal stowing of
the motor. On Terrova and PowerDrive this device is not a
substitute for positioning the Depth Collar against the
Steering Housing and tightening it to guard against
accidental deployment.
3f
Inboard
Marking
Removable
Drill Holes
Base
Boat Deck
3g
Phillips
Pan Head
Boat
Screw
Deck
Removable
Base
4i
Body
Knob
Shaft
Ideal
Control
placement
Head
of Body
Rod
Trolling Motor
fully stowed
Nylon
Hex Nut
Boat Deck
minnkotamotors.com | 3
Publicité
