Publicité
Les langues disponibles
Les langues disponibles
5
l.
After the Rod is cut, replace the Body of the
bracket on top of the Rod and secure it in place
with the Knob.
NOTICE:
Clearance is built into the Body to fit the top
of the Rod in an imperfect cut from the previous step.
m. To fine-tune the height of the Body, loosen the
Nylon Hex Nut at the base of the Rod. Once
loose, rotate the Rod in the Swivel Base in a
clockwise direction to lower it and in a counter
clockwise direction to raise it. Only use the
adjustment at the bottom of the Rod to fine-
tune the height of the Rod to provide adequate
support. Test the placement with the motor in the
stowed position.
n.
Rotate the Rod in place until it is the proper
height to provide adequate support for the Shaft.
Then secure the Rod by rotating the Nylon Hex
Nut down until it is tight against the Swivel Base.
6
o.
To use the Bow Mount Stabilizer Bracket, engage
the Plunger and rotate the Swivel Base so that
the Rod is locked into position.
p.
Rotate the Body so that the cradle aligns with the
motor Shaft. Stow the trolling motor and lower the
motor so that the Shaft is captured in the Body
of the bracket. Secure the Shaft by hooking the
Rubber Strap in place.
CAUTION
The Rubber Strap is only intended to capture the motor
Shaft. Do not constrict any wires routing out of the Control
Head, or otherwise in the Rubber Strap when it is secured
on the Bow Mount Stabilizer Bracket.
For warranty information, please visit
minnkotamotors.com
Part #2374952
minnkotamotors.com.
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
ECN 40101
5l
Rubber
Strap
5n
Swivel Base
Boat Deck
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
Body
Rod
Rod
Nylon Hex
Nut
Rubber
Strap
Shaft
A Johnson Outdoors Company
©2019 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev C
04/19
Publicité
