CASO DESIGN Cremino Mode D'emploi page 15

•
If it is necessary to repair the appliance or to replace the mains lead, send the appliance either
to the specialist dealer you bought it from (specialist tools must be used for repairs), or to your
nearest CASO Braukmann GmbH customer service centre. Repairs to electrical appliances
may only be carried out by qualified specialists. The appliance must not be opened up.
Improper repairs can give rise to significant hazards for the user.
If the appliance is used for purposes other than those intended or used incorrectly, no liability
can be accepted for any damage that may be caused.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance
Technical Data
Power consumption: 1220 W
Mains voltage:
This appliance complies with the following EU Directives:
-
-
-
Prior to Using for the First Time
Before frothing milk for the first time you should steam through about a quarter of a tank full of
water in order to clean the heating system. Proceed exactly as described in the following section
"Frothing Milk" but without putting milk in the milk container. Place as large a receptacle as
possible in the middle of the drip grid and under the milk discharge outlet of the frothed milk spout
(Figure 1/D,J).
Preparation
Warning: only fill the water tank with cold, clear water. Do not use mineral water, distilled water,
milk or other liquids!
Raise the water tank lid (F).
Remove the water tank (G) by the lid and fill with cold, clear water (Figure 1).
Replace the water tank with its lid and push down as for as it will go.
Use
You can use the milk frothing machine to make cappuccino, café au lait and cocoa or simply to
heat up and froth milk (for example as a drink with honey when suffering from a cold).
Assembling and attaching the frothed milk spout (Figs. 1 and 10)
Important: all parts of the frothed milk spout (Figure 2) must be firmly connected to avoid
additional air or milk being sucked in.
Insert the knob for regulating the froth (Figure 2/Q) into the control valve (Figure 2/R) and push
firmly into place.
Insert the control valve (Figure 2/R) into the connector (Figure 2/Q), and connect the milk
discharge outlet (Figure 2/P) to the connector.
Firmly push the complete frothed milk spout onto the steam nozzle (Figure 2/N) until the upper
red seal ring (Figure 7/"arrow") is no longer visible and the steam button (Figure 1/B) can be
pushed down fully.
Join the milk container with lid to the control valve (Figure 1/K,L).
220 – 240 V
73/23/EEC dated 19.02.1973 "Low Voltage Directive", including Amending Directive
93/68/EED
89/336/EEC dated 03.05.1989 "EMC Directive"
15
.