Important - Bradley EFX 50 Installation

Robinet thermostatique mélangeur avec armoire en option
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EFX 50/S19-2250
Installation
WARNING
Failure to comply with proper installation and maintenance instructions could contribute to the valve failure
resulting in severe bodily injury including scalding, chilling, and/or death depending upon system water
pressure changes and/or supply water temperature changes.
Use this Thermostatic Mixing in occordance with ASSE standard 1071. Operation of emergency thermostatic
mixing valves and fixtures must be tested weekly per ANSI Z3358.1. This valve does not provide protection
from pipe freezing.
Output temperature of the valve must be checked and adjusted at initial installation and on a quarterly basis.
Make sure that all water supply lines have been flushed and then completely turned off before beginning
installation. Debris in supply lines can cause valves to malfunction.
NOTICE
Regular checking and cleaning of the valve's internal components and check stops is necessary for
maximum life and proper product function. Periodic Inspection and Yearly Maintenance by a licensed
contractor is required. Corrosive water conditions, and/or unauthorized adjustments or repairs could render
the valve ineffective for its intended service. Frequency of cleaning and inspection depends upon local
water conditions.

IMPORTANT

Read this entire installation manual to ensure proper installation. When finished with the installation, file
this manual with the owner or maintenance department. Compliance and conformity to local codes and
ordinances is the responsibility of the installer.
Consult local building and plumbing codes prior to installation. Should these codes differ from the
information in the Manual, follow the local codes. Inquire with governing authorities for additional local
requirements.
Valve shall be accessible for testing, adjusting and maintenance in the installed position.
Separate parts from packaging and make sure all parts are accounted for before discarding packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
Product warranties may be found under "Products" on our web site at bradleycorp.com.
Bradley • 215-1810 Rev. B; ECN 14-09-031B
2
2/2/2015

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

S19-2250

Table des Matières