Kinderkraft ENOCK Guide D'utilisation page 19

Tighten the oblong bar (3) with the bolts (10) to the emerging structure from both sides at leg half-height.
The structure shall be as shown as the figure IV.
Then gently insert the backrest (5) into the sockets located at the very top of the legs from their inside.
Vertically insert the rectangular nut (from the right side/ leg 1) (15) to the already inserted backrest. Insert
the bolt (9) into the orifice in the leg and then tighten through the backrest into the nut (figure V). Pay
attention that the bolt must match the nut. Repeat this step at another side of the backrest, however
remember not to tighten the bolt to leave play for assembly of other elements. The figure VI shows the
backrest fixed to the structure.
Gently insert the narrow backrest board (14) into the sockets located beneath the backrest at the legs from
inside. Insert the vertically rectangular nut (from the right side/ leg 1) (15) to the already inserted narrow
board. Insert the bolt (9) into the orifice in the leg and then tighten through the board into the nut (figure
VII). Pay attention that the bolt must match the nut. Repeat this step at another side of the narrow board,
however remember not to tighten the bolt to leave play for assembly of other elements. The figure VIII
shows the assembled elements.
If child's feet do not reach the floor yet, fix the small board (6) at the position 1/2/3/4 to serve as a leg rest
and the large board (7) at the position 10/9/8/7/6 to serve as a seat (see: fig. C).
If your child can sit at a table properly and their feet reach the floor, fix the large board (7) at the position
10/9/8/7/6 to serve as a seat. Do not use the small board (6) (see: fig. C).
Firmly tighten all bolts in the chair.
G. Transforming a baby highchair into a chair for older children
In order to transform a highchair into a chair for older children you need to disassemble several elements.
Start from removing the tray (16) and its fittings (17) completely. Use the Allen wrench (12) to loosen the
bolts (18) to be able to remove them from chair's legs. Then loosen the bolts (9) in the chair to make the
structure become a bit disassembled. Remove the belts from narrow orifices in the small board (6) and the
narrow backrest board (14). Then remove the handle and the safety belts from the structure. Adjust and
align the seat board and the leg rest to child's size as specified in the section C. Position selection for the
baby highchair and the chair for older children.
Firmly tighten all bolts in the chair.
H. Cleaning
The chair should be cleaned with a clean and dry cloth. In case of more serious stains you can use a slightly
damp, though not soaking, clean cloth.
I. Warranty
A. All Kinderkraft products are covered by a 24-month warranty. The warranty period begins on the date
of releasing the product to the Buyer.
B. The warranty is valid for products sold in the following countries: France, Spain, Germany, Poland,
United Kingdom, Italy.
C. In countries not listed above warranty terms and conditions are determined by the Seller.
D. It is possible to extend the warranty period to 120 months (10 years). Full text of the terms and
conditions and warranty extension registration form are available at
E. The warranty is valid only in the country where the purchase was made.
19
WWW.KINDERKRAFT.COM