Kinderkraft ENOCK Guide D'utilisation page 17

position is 10, while the lowest one is 1.
Chair for older children:
In this position the large board is used a seat and can be set in the positions 6-7-8-9-10. The small board
serves as a leg rest and can be set in the positions 1-2-3-4, depending on a child foot position, or
disassembled. Do not use the tray and the bow-shaped handle with safety belts in this position.
D. Assembly of the baby highchair
You will need the Allen wrench (12). Perform assembly on soft surface that will not damage surface of
elements.
Start from assembling the leg (1) with the cross-bar (4). Notice that there are protruding pins in the cross-
bar. Gently adjust the protruding element with the first orifice from the bottom. Look at the figure I and
adjust the cross-bar in the way enabling you to insert the cylinder nut (11) into the orifice on the side
element surface. Insert the bolt (13) into the orifice in the leg and tighten it through the cross-bar into the
nut. Pay attention that the bolt must match the nut. Then use the Allen wrench (12) to tighten the bolt.
Repeat the aforesaid steps with the next cross-bar (4) by fixing it to the same leg (1). Tighten another leg (2)
to the structure consisting of two cross-bars and one leg. At this and subsequent stages we suggest to leave
the leg 2 slightly loosened in order to enable assembly of next elements inside the chair. The emerging
structure must look as shown at the figure II.
Tighten the oblong bar (3) with the bolts (10) to the emerging structure from both sides at leg half-height.
The structure shall be as shown as the figure IV.
Then gently insert the backrest (5) into the sockets located at the very top of the legs from their inside.
Vertically insert the rectangular nut (from the right side/ leg 1) (15) to the already inserted backrest. Insert
the bolt (9) into the orifice in the leg and then tighten through the backrest into the nut (figure V). Pay
17