Conceptronic CH3MNAS Mode D'emploi page 45

[ HDD configuration – RAID 0 volume ]
When "RAID 0" or "RAID 1" is selected as HDD configuration, the CH3MNAS will ask for the desired
capacity of the RAID volume. The maximum capacity for the RAID volume is shown in the top of the
window.
D. Enter the desired capacity for the RAID volume. The remaining space will be used for a JBOD
volume. Click "Next" to proceed.
The HDD configuration is being created and the volumes will be formatted according to the entered
configuration in the previous steps.
Note: The format of the Harddisk can take a while, depending on the chosen HDD configuration and the
capacity of the Harddisk. Do not turn off or unplug the device during format!
When the creation and format of the HDD configuration is complete, you will see a summary of the
created HDD configuration.
E. The CH3MNAS must be restarted in order to use the created HDD configuration. Click "Restart" to
proceed.
F. The web-based configuration will inform you on the waiting time before the CH3MNAS is available
again after the restart. Click "OK" to restart the CH3MNAS.
[ HDD configuration – Formatting ]
[ HDD configuration – Format complete ]
[ HDD configuration – RAID 1 volume ]
ENGLISH
45