Get Ready For Usage - Conceptronic CH3MNAS Mode D'emploi

ENGLISH

3.2 Get ready for usage

A. Connect the power adapter to the DC power connector at the backside of the CH3MNAS.
B. Connect the AC power cable to the power adapter of the CH3MNAS and to a free wall outlet.
C. Connect the included Ethernet cable to the LAN port on the backside of the CH3MNAS and to your
network.
Note: We advise to connect the CH3MNAS to a DHCP enabled network for easy configuration. If you
connect the device directly to your computer, or to a network without DHCP server, you need to
setup a temporary static IP address for your computer to configure the CH3MNAS.
D. Turn on the CH3MNAS by pressing the power button on the front panel.
During the system startup of the CH3MNAS, the power LED will blink. After +/- 1 minute, the power LED
will become solid blue, which indicates that the CH3MNAS is started and ready to be used.
Note: Before you can fully benefit from all the features of the CH3MNAS, you need to configure the
device first. You can access the configuration of the CH3MNAS easily by using the Grab'n'Go Easy
Finder, which is explained in chapter 4.
38