Ceado E7 Manuel D'utilisation page 26

26
CLEANING
It is important to keep the appliance clean and in good
working order to ensure optimum quality of the products
and long life of the appliance.
Cleaning of the appliance must be carried out by
persons with knowledge and practical experience of
the appliance.
At the end of each working day, clean the outer
surfaces dirty with coffee ( motor housing, tray, doser
etc.). Clean the appliance completely at least once a
week.
Always disconnect the plug of the appliance
from the power socket before cleaning it.
Clean the motor housing and the tray with a
cloth dampened with water or alcohol.
Wipe with a dry cloth.
Never put the appliance under running water and never immerse in water.
Once the hopper has been removed it can be washed with lukewarm water and neutral soap,
then rinse it and dry well.
Cleaning the doser unit requires great care because inside it there is an electromechanical
device which could get damaged.
- Use a brush or a paintbrush (Fig. 8) to clean the most hidden areas inside the unit and a dry
cloth for the other surfaces.
MAINTENANCE
Maintenance must be carried out exclusively by qualified technical personnel.
Care for the mechanical and electrical parts of the appliance is indispensable in order to guarantee
their safety and efficiency. If any parts need replaced, authentic spare parts must always be used.
ASSEMBLY OF PRESS
Before performing any assembly operations, unplug the appliance.
To install the press supplied (diameter 53, 54,5 and 57,5 mm), proceed as follows:
1
Loosen the screw at the bottom of the doser as shown in Fig. 9 using a Phillips screwdriver and
set it aside.
GB
Fig. 8