Installing The Microphone - Nolangroup N-Com MCS II Mode D'emploi

3.1.

Installing the microphone

JET HELMETS OR FLIP-UP HELMETS
 Prepare the microphone by inserting the microphone clamp, being careful to position it properly
(Fig. 6)
Note: the flat part of the clamp must be facing upward when the microphone is positioned as
shown in figure 7.
 Position the microphone in its support as shown in figure 8, being careful that the fluorescent
clamp is facing toward the inside of the helmet.
 Insert screw and washer in the microphone clamp; use the key to screw in the microphone
securing screw to the shell frame.
Fig. 6
Fig. 8
Fig. 7
Fig. 9
MCS II
9