Removing The Mcs Ii System - Nolangroup N-Com MCS II Mode D'emploi

EN
4.

REMOVING THE MCS II SYSTEM

Fig. 20
After releasing the connector from the shell, also remove the right part by releasing the Basic kit2 MCS
from the shell pins. Now remove the entire Basic Kit2 MCS from the helmet.
14
 To remove the MCS II system from the
helmet, remove the earphone and the
comfort cheek pads as shown in the
assembly operations
remove the polystyrene cheek pads. Remove
the protection plate, then, looking at the
helmet from the
connector by acting on the fastening clasp
as illustrated in the figure.
(Chapter 3). Then
outside, release the