Operation Of The Mcs Ii System; Maintenance - Nolangroup N-Com MCS II Mode D'emploi

5.

OPERATION OF THE MCS II SYSTEM

Hook up the cable to the motorcycle, then to the MCS II system. The audio of the system installed on
the motorcycle is now transferred to the helmet.
You can use the interphone system on the motorcycle by connecting both the pilot's helmet and the
passenger's to the motorcycle. Each helmet must be equipped with the MCS II system.
Volume levels of the radio and of intercom have to be set from the motorbike's audio system, as
desired.
When using the INTERCOM function, the volume has to be set at a comfortable level for conversation.
Do not increase the volume too much to avoid background interference.
For all audio settings and adjustments, please read your motorbike manual.
Warning: Connect the cables so that they are free and do not hinder riding nor reduce the freedom of
movement, and do not wind them around the limbs, bust or neck. Do not lock the connectors so
that, if necessary, they can be easily disconnected.
Attention: do not pull the cable. Do not use the cable to lift the helmet. Do not pull the cable to
separate the two connectors. To separate the connectors, hold them and pull them in opposite
directions.
6.

MAINTENANCE

The N-Com does not require any special maintenance tasks.
In case you use the kit when it rains, dry off the wet parts of the helmet.
MCS II
15