Installation - Nolangroup N-Com MCS II Mode D'emploi

3.

INSTALLATION

Important: Prior to installing the N-Com system, it is recommended to write down the identification
code affixed to the product (see chapter 7.5).
 Remove the "N-Com" protection plate located on the helmet shell (Fig. 1) and open the helmet
chin guard (flip up helmets).
 Remove the right and left cheek pads from the helmet (see specific instructions provided in the
user manual of the helmet).
 Remove the back of the comfort padding by pulling on the neck roll until it separates from the
shell.
Fig. 1
Fig. 3
Fig. 2
 Temporarily put the padding on the outside
of the helmet (Fig. 2).
 Remove the N-Com cover from the helmet
border gasket. Push from the inside of the
helmet to facilitate the removal (Fig. 3).
MCS II
7